Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 74)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
SYSTEM CONFIGURATION / 65
ROW ASSIGNMENT
Row assignment automatically populates with the module address and
module type entered at the Module Configuration screen.
IMPORTANT: Number of seed rows assigned to a module and the Row
MAP value automatically populates when the Auto
Config button is used to configure installed sensors.
To Manually Assign Rows to a Module:
1. Press the Seed Rows button
2. Press the Row Assign button.
3. Use the rotary knob to highlight the yellow input box.
4. Press in the rotary knob to display virtual keyboard and enter desired
number of rows assigned to the module.
5. Select the Check button and push in rotary knob to accept.
Figure 56
Row Assignment Screen
ADDING NUMBER OF ROWS
The Number of Rows column displays the total number of seed sensors that
are connected to each module. The Row #’s value is automatically
configured by Auto Config for proper row numbering for each module based
on the module address value and number of rows.
A Module Next Page button displays if more than 12 modules are
connected. Press the Module Next Page button to display additional
modules.
NOTE: Only modules that support seed
sensors display on the Row
Assignment screen. To Edit Number Of Rows:
1. Enter the number of rows to be assigned to each module.
2. Press the Sensor Detect button to detect and test seed sensors.
– An hour glass appears in the upper right corner while the sensors
are tested.