Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 27)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
18 / COMPONENT INSTALLATION
Figure 17
Incorrect Seed Sensor Module Connection
Failure to correctly install seed sensors will result in incorrect row
assignment on the planter monitor display functions and alarms.
HOPPER LEVEL SENSORS
The system is compatible with the DICKEY-john planter hopper level
sensors. Three hopper level sensors can be connected to the PCM module.
The hopper sensor is connected to the actuator harness. The hopper level
connection is labeled HOPPER 1-3.
RPM SENSORS
The system is compatible with all existing DICKEY-john RPM sensors. Two
RPM sensors may be connected to the PCM module. The sensor is
connected to the actuator harness. The RPM sensor connection is labeled
RPM 1-2.
AIR PRESSURE SENSORS
The system is compatible with DICKEY-john air pressure sensors. Three air
pressure sensors with adapter harness connects to the RPM harness
connection labeled RPM1.
When connecting seed sensors to the modules, the following requirements
must be observed:
All seed sensors installed must be connected to the seed sensor
harness SEQUENTIALLY starting with the Row 1 input. In the event
that not all row inputs on the module are used, the unused inputs
must be the last inputs on that module.