Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 102)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
OPERATION / 93
OPERATE SCREEN SYMBOLS
TARGET RATE
The Target Application Rate displays when master/control switch is off. The
actual applied rate appears during Operate mode.
INCREASE/DECREASE % RATE
The Increase/Decrease rate is the percentage change being applied each
time the Material Increase/Decrease button is pressed during Operate
mode.
TARGET PRESET RATE
The Preset Rate is the applied rate that was entered at the Material
Configuration Setup screen and increases or decreases when the Material
Increase/Decrease button is pressed during Operate mode.
IMPLEMENT LIFT SWITCH
When an implement lift switch is installed, the Main Work screen will identify
if the implement is in the up or down position. Using an implement lift switch
automatically turns the control channels on and off without turning the
master/control switch off. The Implement Lift Indicator must be in the Down
position for the control channels to operate. The Implement Lift Switch
box on the Ground Speed Configuration screen must be enabled if an
implement lift switch is used.
Refer to the Implement Lift Sensor instructions for installation location.
ROW INDICATORS
Row Indicators in the bar graph area on the bottom of the Work screen
indicate seed rate for each row. The size of the bar graphic is automatically
proportional to the screen size. The following symbols illuminate in the bar
graph area:
Figure 72
Row Indicator Symbols