Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 101)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
92 / OPERATION
START
1. Lower the implement to operating position, engaging the implement
switch, if present and enabled.
2. With the hydraulic system engaged and the tractor at its normal
operating RPM, set the master/control switch to the On position. All
enabled control channels will begin controlling at the current ground
speed. All accumulators will begin recording data.
When the implement is down and the master/control switch in the
On position, the machine is fully operational. All necessary
precautions must be taken to ensure user safety. Failure to
practice all necessary caution may result in serious injury or
death.
STOP
1. Set the master/control switch to the Off position. All control channels
will cease operation and all data accumulation will halt.
2. Operation will immediately stop when the ground speed is 0 or the
implement is raised to disengage.
Figure 71
Main Work Screen Functions