HP 220 - Manual (Page 99)

0D2 DmbtinJ: En e ha he bel i
c ec ly i i ned a nd he
ca iageĆm gea and he l we a f
he d ble lley
Carriage-motor
connector
1
2
Tensioner wheel
Small drive belt
Motor gear
Double pulley
Loosen
1 Remove the electronicsĆenclosure
cover D page 6Ć5.
2 Remove the window D page 6Ć15.
3 Remove the center cover D page 6Ć16.
4 Remove the right endcover D page 6Ć19.
Torx-15
5 Disconnect the carriageĆmotor cable from
the main PCA (connector labelled Y), and
from the lowest ferrite holder on the
rightĆhand side of the plotter.
6 Pressing the small drive belt against the
tensioner wheel in the belt tensioner to
loosen the belt, slide the belt off of the
motor gear; then carefully release your
hand from the the tensioner wheel.
7 Loosen the two carriageĆmotor screws
about 1/2 cm (about 1/4 inch).
6Ć35 Removal and Replacement C3187Ć90000
Removing the Carriage ,YĆAxis. Motor