HP 220 - Manual (Page 153)

Error
Cartridges Error
Ready Error
8Ć5 Troubleshooting C3187Ć90000
Errors Indicated by LEDs
The
Error
LED on the front panel works in combination with the other
LEDs to specify the type of error that has occurred. The three possible
states of any LED are representedlike this:
Off On Flashing
User Errors
User errors are associatedwith user settings or user actions andmay be solvedby the user
without calling a Customer Engineer. They are indicated by the
Error
LED flashing.
(Further Information D User's Guide, chapter 4, Troubleshooting.)
Error
and
Cartridges
flashing
Possible Causes Corrective Action
An error was detected during the
cartridgeĆalignment routine.
1. Remove the cartridges.
2. Ensure that the protective tape has been removedand
that the contacts are clean.
3. Replace the cartridges.
4. If the LEDs do not stop flashing when you lower the
window, replace both cartridges with new ones.
See also D later in chapter, w Frequent Cartridge Failure.
An error was detected while scanning a
setup sheet.
1. Check the quality of the media and print of the setup
sheet.
2. If the quality appears acceptable, try loading the sheet
again face down. If not, use a newly printed setup sheet.
3. If the error persists, perform the setupĆsheet calibration.
Error
and
Ready
flashing
Possible Causes Corrective Action
The current plot is too large for the
plotter's memory
To be able to perform this plot, you have to install more
memory. (If the plot is a raster plot, it might work if you
sendit with a no negative motion RTL command.)