HP 220 - Manual (Page 91)

7 Remove the screws that attach the
bottom coverto the plotter, and lift the
coverclearof the plotter.
D/A1Ćsize plotters have 8 screws.
E/A0Ćsize plotters have 10 screws.
Torx-20
Reassembling: Ensure that the two
flags on the media sensor are correctly
positioned (see following procedure).
8 Pull the media sensorstraight out
towards you, freeing it from the
underside of the entry platen.
9 Cut the plastic tie that fastens the
mediaĆsensorcable to the underside of
the entry platen.
10 Lift the media sensorand cable clearof
the plotter
Plastic tie
Take care not to cut the mediaĆsensor cable
itself.
C A U T I O N
Calibration: After having reassembled the
plotter, perform the mediaĆsensor calibration
(Details D chapter 7).
6Ć27 Removal and Replacement C3187Ć90000