HP 220 - Manual (Page 101)

E Remove the electronicsĆenclosure
cover D page 6Ć5.
F Remove the window D page 6Ć15.
G Remove the center cover D page 6Ć16.
4 Remove the right endcover D page 6Ć19.
5 Remove the frontĆpanel
assembly D page 6Ć32.
N Remove the carriage motor D page 6Ć35.
7 Disconnect the mediaĆmotor cable from
the main PCA (connector labeled X) and
from the uppermost ferrite holder on the
rightĆhand side of the plotter.
Paper-motor
connector
SO OLOGOHOGOF
In the following stepsA take care not to
cut yourself on the encoder stripD
8 Remove the two screws that secure the
driveĆroller gear to the driveĆroller
shaft.
Torx-10
Reassembling: Push the gear nt the
shaft as far as it will g Align the h les
n the gear with the h les n the shaft
9 Remove the driveĆroller gear from the
driveĆroller shaft.
The gear may be stiff t rem ve
6Ć37 Removal and Replacement C3187Ć90000
Removing the Media ,XĆAxis. Motor