HP 220 - Manual (Page 107)

1 Remove the window D page 6Ć15.
2 Remove the center cover D page 6Ć16.
3 Remove the left endcover D page 6Ć18.
4 Remove the right endcover D page 6Ć19.
5 If the maintenance you need to perform
requires you to remove the trailing cable
as well as the trailingĆcable guide, then
remove the trailing cable now D page 6Ć29.
6 Remove the screw that attaches the
trailingĆcable guide to the tensioner
housing.
Tensioner
housing
Trailing-cable guide
Torx-15
C A U T I O N
Exercise care to avoid damaging the ferrite
ring when carrying out the following
instructions.
7 Cut the plastic tie, on the spring in the
ferrite ring, located where the trailingĆ
cable guide attaches to the YĆdrive
bracket.
Ferrite ring
Spring
and tie
Trailing-cable
guide
8 Using a screwdriver, compress and
release the spring frombetween the
inside surface of the ferrite ring and the
trailingĆcable guide.
C A U T I O N
Handle the trailing cable and the
trailingĆcable guide with care.
0D2 DmbtinJ: Attach a new plastic tie
6Ć43 Removal and Replacement C3187Ć90000
Removing the TrailingĆCable Guide