HP 220 - Manual (Page 84)

1 Remove the window D page 6Ć15.
2 Remove the centercoverD page 6Ć16.
3 Remove the left endcoverD page 6Ć18.
4 Detach the linkage spring from the
YĆtensionerbracket.
Reassembling: Attach the spr ng through
the two small holes, as n the d agram.
5 Remove the two shoulderscrews that
attach the automatic cartridgeĆadjust
linkage to the left sideplate and lift the
linkage clearof the plotter.
C A U T I O N
Reassembling: Do not crossĆthread or
overĆtighten the screws.
Reassembling: Rest the bottom arm of the
l nkage on top of the stepperĆmotor shaft.
Stepper-motor
shaft
Bottom arm
of linkage
Torx-15
6Ć20 Removal and Replacement C3187Ć90000
Removing the Automatic CartridgeĆAdjust Linkage