HP 220 - Manual (Page 82)

Reassembling: When replacing screws on any plastic part, always begin
by gently twisting the screw in anticlockwise with your hand, until the
screw finds the thread path and clicks, and then twisting the screw in
clockwise with your hand, before using a screwdriver. This is to avoid
crossĆthreading. Do not overĆtighten the screws.
6 Remove the three screws from the left
side of the left endcover.
1 Remove the window D page 6Ć15, and the center cover D page 6Ć16.
2 Remove the two screws on the left front trim and the two screws on the left back trim.
C A U T I O N
Torx-15
Torx-15
3 If the plotter is mounted on legs, loosen
the twoleftĆhand screws that attach the
plotter to the legs.
4 Maintaining an even pressure on the top
and bottom of the endcover, pull it to the
left, away from the plotter.
Do not let the windowĆpivot spring drop out
of the endcover
6Ć18 Removal and Replacement C3187Ć90000
Removing the Left Endcover