Heat & Glo Fireplace XLR-PLUS-PB-AU - Manual (Page 59)

59 Heat & Glo • XLR-PLUS-N-AU, XLR-PLUS-PB-AU • 2264-900 Rev. o • 1/13
Figure 13.14. Dimensions of Tonic Decorative Front.
A
B
D
C
E F
TONIC FRONT
Figure 13.15 Glass and Heat Shield - Martini and Tonic
Figure 13.16 Martini Front Gap
Figure 13.17Tonic Front Gap
Glass Lip Heat Shield seats in glass frame.
Gap below Martini front
must not be covered - it
is for cool air flow when
the fan is running.
Gap between Tonic front and Tonic glass lip. This
gap is for cool air flow when fan is running.
LOWER GLASS HEAT SHIELD
(MARTINI & TONIC FRONTS)
UPPER GLASS HEAT SHIELD
(TONIC ONLY)
Retain top upper glass heat shield with tinnerman clip on
each side of glass frame.
This appliance requires field-installation of heat shield(s) on
the firebox glass frame. These shields function to manage
convective heat transfer during blower operation. These
shields are critical to the performance and reliability of the
appliance because they prevent overheating of gas control
components.
For installation finished with the Martini decorative front, a
single lower glass heat shield is installed in the bottom of the
glass frame. This shield will be installed prior to installing the
decorative surround and glass. See Figure 13.15. It is also
critical that the required air space is maintained between the
underside of the Martini surround and the adjacent finishing
materials. See Figure 13.16.
For installations finished with the Tonic decorative front, both
an upper and lower glass heat shields are installed in the top
and bottom of the firebox glass frame. These will be installed
prior to installing the framed mesh and the Tonic surround.
See Figures 13.15 and 13.16.
WARNING! Risk of Valve / Control Damage! This appliance
requires field-installation of heat shields onto the firebox glass
frame. Do not operate this appliance without the specified heat
sheild(s).
A
Top of decorative front to bottom of
appliance.
TN-SLR-**
26-3/8 in. 670 mm
TN-XLR-**
27-1/8 in. 689 mm
B
Bottom of decorative front to bottom of
appliance.
6-7/8 in. 175 mm
C
Inside dimension of decorative front
(width).
39 in. 991 mm
D
Outside dimension of decorative front
(width).
44-1/2 in. 1130 mm
E
Inside dimension decorative front
(height).
TN-SLR-**
13 in. 330 mm
TN-XLR-**
13-3/4 in. 349 mm
F
Outside dimension of decorative front
(height).
TN-SLR-**
19-1/2 in. 495 mm
TN-XLR-**
20-1/4 in. 514 mm
