HP LASERJET 300 - Manual (Page 9)

1 Setup
The HP LaserJet MFP Analog Fax Accessory 300 enables the HP multifunction product (MFP) to
function as a standalone analog fax machine.
This guide describes the fax functions of this product in the following sections:
● Parts included with the fax accessory
● Installing the fax accessory
● Verifying fax operation
● Required fax settings
In addition, this guide provides information on product specifications and regulatory information.
NOTE: In addition to the analog fax feature, the MFP also supports LAN faxing. LAN faxing is managed
by the HP MFP Digital Sending Software Configuration Utility which is a separate product and is not
covered in this document. For information about LAN faxing, see the HP MFP Digital Sending Software
User Guide or the HP MFP Digital Sending Software Support Guide. If both the analog fax accessory
and the LAN fax are installed, only one fax can be enabled at a time.
You should save this guide so that you can refer back to instructions on specific fax features.
NOTE: If the MFP did not come with the fax accessory installed, you need to install it as described in
this chapter.
NOTE: If the MFP came with the fax accessory installed, you need to remove the fax connection cover,
connect the phone cord, and then perform the initial fax configuration that is also described in this
chapter. The fax connection cover is located on the phone connector on the formatter rear panel.
ENWW 1