Send-fax messages, Enww fax error messages 107 – HP LASERJET 300 User Manual
Page 115
Send-fax messages
Table 4-1
Send-fax messages
Message
Error No.
Description
Action(s)
Cancelled
0
Fax was cancelled by user at
control panel of MFP.
None.
Success
n/a
Fax sent successfully.
None.
Fail Busy
0
The receiving fax machine is
busy.
The fax will be retired
automatically (if configured),
otherwise try resending fax
later.
No Answer
0
The receiving fax machine is
not answering the call.
The receiving fax machine
may be disconnected or
turned off; contact the
receiver to check the
machine. Try resending.
Compression Error
Any
Fax may be corrupted or not
sent.
Try resending fax.
No Dial
0
No dial tone is detected when
sending the fax.
Verify the phone line is active;
set the sending fax to "not" to
detect a dial tone.
Modem Fail
Any
Unexpected or bad response
from the internal fax modem
to MFP.
Try resending fax; if the error
persists, contact service.
Communication Error
17 or 36
Lost telephone connection
between sender and receiver.
Try resending the fax.
Communication Error
Any besides 17 or 36
General communications
issue where the fax
transmission was interrupted
or did not proceed as
expected.
Try resending fax; if the error
persists, contact service.
Space Fail
0
Unable to read or write the fax
image file to disk; could be
corrupt MFP disk or no space
available on the MFP's disk.
Try resending fax; if the error
persists, contact service.
Page Fail
0
Incompatible page width, or
page had too many bad lines.
Try resending fax; if the error
persists, contact service.
Memory Error
0
Out of RAM memory on MFP. If error persists, may need to
add RAM to MFP.
Job Fail
Any
Fax failure; the fax job did not
complete.
Try resending fax; if the error
persists, contact service.
Power Failure
0
A power failure occurred
during the fax transmission on
the sending fax MFP.
Try resending the fax.
No Fax Detected
17 or 36
No fax machine was detected
at receiving end.
Verify fax number and have
receiver verify fax machine is
on and connected; then try
resending fax.
ENWW
Fax error messages 107