HP LASERJET 300 - Manual (Page 51)

HP MFP Digital Sending Software Configuration Utility
To access the analog MFP fax settings by using the DSS configuration utility, perform the following
steps.
1. 1. Start the utility (on the computer or server) to open the main screen.
2. Select the MFP and click the Configure MFP button on the main screen, and then click the Send
to Fax tab to open the Fax Settings screen.
3. To enable the fax capabilities on the MFP, select Enable Send to Fax. To access Analog-fax
settings, select directly from the MFP's internal modem in the Send Faxes drop-down list. On the
Fax Settings screen make any changes to the settings and click OK to accept the settings. Select
Advanced to open the Advanced MFP Modem Settings screen for additional fax settings.
For information about these settings, see the setting descriptions in this guide.
4. After you have made changes to the settings, click OK to accept the settings.
In addition to configuring a single MFP, you can also configure multiple devices. For more information
about the HP MFP Digital Sending Software Configuration Utility, see the HP MFP Digital Sending
Software User Guide or the HP MFP Digital Sending Software Support Guide.
NOTE: Depending on the capabilities and settings of your fax method, some of these options might
not be available or configurable.
ENWW Remote fax configuration 43