HP LASERJET 300 - Manual (Page 107)

Checking fax accessory status
If the analog-fax accessory does not appear to be functioning, print a Fax Accessory Page to check the
status.
Print the Fax Accessory Page on the HP LaserJet 4345mfp and 9040/9050mfp, and the HP Color LaserJet
4730mfp and 9500mfp
1. On the control panel, press the Menu button to open the main menu.
2. Touch INFORMATION PAGE to open the information menu.
3. Touch PRINT CONFIGURATION to print the configuration pages.
Print the Fax Accessory Page on the HP LaserJet M3025 MFP, M3027 MFP, M4345 MFP, M5025 MFP, M5035
MFP, M9040 MFP, M9050 MFP and HP Color LaserJet CM4730 MFP and CM6040 MFP Series
1. On the control panel, scroll to and touch the Administration icon to open the Administration menu.
2. Scroll to and touch Information .
3. Scroll to and touch Configuration/Status Pages .
4. Scroll to and touch Configuration Page to print the configuration pages.
On the Fax Accessory Page of the Information Page, under the HARDWARE INFORMATION heading,
check the MODEM STATUS. The following table identifies the status conditions and possible solutions.
OPERATIONAL / ENABLED 1 The analog-fax accessory is installed and ready.
OPERATIONAL / DISABLED 1 The fax accessory is installed and operational, however,
HP Digital Sending utility has either disabled the MFP fax
feature or has enabled LAN fax. When LAN fax is enabled, the
analog-fax feature is disabled. Only one fax feature, either LAN
fax or analog fax, can be enabled at a time.
NON-OPERATIONAL / ENABLED/DISABLED 1 A firmware failure has been identified. The firmware should be
updated, see
Firmware upgrades on page 117 .
DAMAGED / ENABLED/DISABLED 1 Fax accessory has failed; reseat the fax accessory card and
check for bent pins. If the status is still DAMAGED, replace the
analog-fax accessory card.
1 ENABLED indicates that the analog fax accessory is enabled, turned on; DISABLED indicates that LAN fax is enabled (analog
fax is turned off).
ENWW Checking fax accessory status 99