Enterasys Networks Network Card - Manual (Page 77)

RiverMaster Administrator’s Guide
65
Chapter 3 Routing
Configuring an ANG-3000/7000
4 Do one of the following:
– Click Apply to save the OSPF parameter changes.
– Click Cancel to close the window without saving your changes.
– Click Reset to the return the interface’s protocol properties to
their default settings.
Creating Static Routes
To configure a static route between an ANG interface and another device,
perform the following steps:
1 Open the Configuration pullout.
2 In the list of Aurorean devices, expand the tree list under Servers
(click the + symbol).
3 Expand the tree list under the name of your ANG.
4 Click on Routing to display the routing parameter tab pages.
5 Click on the Interface tab to display the routing protocol(s) selected
for each interface.
6 From the Interfaces menu, choose the ANG Ethernet interface to
configure (External or Trusted).
7 In the Routing Protocol Selection list, double click Static Routes and
click Add in the Static Route Configuration window.
The Static parameter tab page is displayed as shown in Figure 38.