Configuring ang ip addresses – Enterasys Networks Network Card User Manual
Page 232
220
RiverMaster Administrator’s Guide
Configuring ANG IP Addresses
Appendix B
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
Configuring ANG IP Addresses
This section describes how to configure the ANG’s name and Domain names,
IP addresses and subnets, and Intelligent Client Routing. This action marks
the actual start of the process to write information to the floppy disk.
NOTE
If the Remote Gateway configuration procedure is canceled at any point,
it must be restarted here.
To set IP Address values, begin floppy disk configuration with these steps:
1
Under Remote Gateways, click Configure Remote Gateway.
The Remote ANG Configuration screen appears as shown in
Figure 122.
Figure 122 Remote ANG Configuration Window