Enterasys Networks Network Card - Manual (Page 49)

RiverMaster Administrator’s Guide
37
Chapter 3 General Aurorean Network Gateway Settings
Configuring an ANG-3000/7000
General Aurorean Network Gateway Settings
General network settings for the ANG include:
H The current and possible future IP addresses for the server.
H Enabling Aurorean Virtual Network’s Intelligent Client Routing
feature which provides you with a measure of control over a
Aurorean Client’s access to the Internet.
H Addresses for the Domain Name System (DNS), Windows Internet
Name Service (WINS), and Network Address Translation (NAT)
servers used by remote clients for name resolution.
To set general network settings for the ANG, perform the following steps:
1 Open the Configuration pullout.
2 In the list of Aurorean devices, expand the tree list under Servers
(click the + symbol).
3 Expand the tree list under the name of your ANG.
4 Click on General to display the general network settings tab pages.
A sample General settings window appears as shown in Figure 18.
The IP Address field is read-only and displays an address assigned to
the ANG during installation. If the ANG is equipped with a single
Ethernet interface, this field shows the address of the Trusted port. If
the ANG is equipped with dual Ethernet interfaces, this field shows
the address of the External port.