Enterasys Networks Network Card - Manual (Page 250)

238
RiverMaster Administrator’s Guide
Configuring Routing Interfaces Appendix B
ANG-3000/7000 Preconfiguration Stored on a Floppy Disk
5 Set the RIP Route Importing/Exporting options as follows:
– To allow the Aurorean Network Gateway interface to learn new
routes, place a check next to Enable Import. If you enabled the
Intelligent Client Routing feature, you should turn on Enable
Import to allow the ANG to pass known reachable addresses to
the remote client.
– To cause the ANG to advertise its known routes, place a check
next to Enable Export. This setting is required to allow the ANG
to advertise the reachability of virtual subnets to other devices on
the network.
6 Do one of the following:
– Click Apply to save the RIP configuration changes, click Cancel
to close the window, and click Next to continue configuration.
– Click Cancel to close the window without saving your changes.
– Click Reset to the return the interface’s protocol configuration to
its original setting.
Configuring OSPF on an Interface
To enable OSPF on an interface, perform the following steps:
1 In the OSPF Interface window, shown in Figure 136, Type the OSPF
password used by routers on your network in the Authentication
Password field.
OSPF authentication passwords are used by routers to determine if
they should accept updated routing information sent from another
router. If your routers do not authenticate updates, leave this field
blank.
NOTE
Passwords are limited to 8 characters or less.