Blackmagic Design URSA Mini Pro 12K (PL) - Manual (Page 218)

Attaching the EF Mount
1 2
Place Blackmagic URSA Mini Pro vertically on a
solid, clean bench top to ensure that the mount
can be inserted vertically. If changing from
the PL to the EF mount, ensure that you have
removed the PL baffle before inserting the EF
mount. Carefully place the Blackmagic URSA Mini Pro
EF lens mount onto the camera body ensuring
the red dot is at the 12 o’clock position.
3 4
1 3
4 2
Using a 2mm Hex driver or torque wrench set to
0.45Nm, loosely turn the four mounting screws
until nitial contact is made with the shoulder of the
lens mount. Confirm the lens mount is level and correctly
aligned, then tighten the screws in the order
shown here to an even pressure without over-
tightening the screws.
NOTE When removing the EF mount, simply follow the instructions in reverse order
from step 4 to step 1.
218 Interchangeable Lens Mount