Blackmagic Design URSA Mini Pro 12K (PL) - Manual (Page 184)

NOTE Before installing Blackmagic Camera Fiber Converter you should check that
URSA Mini’s internal software is version 4.4 or above and URSA Broadcast is 4.6 or
above. You can check your software version on page 4 of the camera’s ‘setup’ menu.
For more information on updating your camera firmware see the section ‘Blackmagic
Camera Setup Utility’ in this manual.
When attaching Blackmagic Camera Fiber Converter, you will need the following tools:
‚ 1 x phillips head screwdriver
‚ 1 x 2.5mm Hex driver
To attach the Blackmagic Camera Fiber Converter to
your URSA Mini or URSA Broadcast, you will need a large
phillips head screwdriver and a 2.5mm Hex driver
To mount and connect Blackmagic Camera Fiber Converter:
1 2
Ensure your camera is powered off. If using
URSA Mini Pro or URSA Broadcast, power
it off by moving the power switch to ‘off’. Remove the battery plate or molex power
cover plate, if attached, using a phillips
head screwdriver.
3 4
Attach Blackmagic Camera Fiber Converter’s
mounting bracket using 6 x 2.5mm Hex screws. Plug the molex connector on Blackmagic
Camera Fiber Converter into the molex power
socket on your camera’s rear panel.
184 Getting Started with Blackmagic Fiber Converters