ProSoft Technology ILX34-AENWG - Manual (Page 88)

Diagnostics and Troubleshooting ILX34-AENWG ♦ Point I/O Platform
User Manual Wireless POINT I/O Adapter
Page 88 of 177 ProSoft Technology, Inc.
August 16, 2013
Initial Network Configuration
Field Description
Ethernet Interface Configuration Static - uses a fixed IP address
Dynamic DHCP - obtains an IP address from a DHCP server
Network Interface
Field Description
IP Address The IP address identifies each node on the IP network (or
system of connected networks). Each TCP/IP node on a
network (including the Ethernet module) must have a unique IP
address.
This value must match the IP address entered on the General
Tab of the Module Properties dialog box in RSLogix 5000.
Subnet Mask Subnet addressing is an extension of the IP address scheme
that lets a site use a single net ID for multiple physical networks.
Routing outside of the site continues by dividing the IP address
into a net ID and a host ID via the class. Inside a site, the subnet
mask is used to redivide the IP address into a custom net ID
portion and host ID portion. This field is set to 0.0.0.0 by default.
Gateway Address A gateway connects individual physical networks into a system
of networks. When a node needs to communicate with a node
on another network, a gateway transfers the data between the
two networks. The following figure shows gateway G connecting
Network 1 with Network 2.
Primary Name Server Enter the IP address of the primary DNS server to use for
resolving (or translating) names to IP addresses
Secondary Name Server Enter the IP address of the secondary DNS server to use for
resolving (or translating) names to IP addresses
Domain Name Domain (or domain zone) of which the ILX34-AENWG is a part.
This value is used during name resolutions if a fully qualified
name is not provided, and also for DNS updates.
Ethernet Link Port 1 / 2
Field Description
Port x Enable Enable or Disable
Autonegotiate Status Autonegotiate Speed and Duplex - determine speed and duplex
by negotiating with connected devices
Force Speed and Duplex - specify speed and duplex, setting
must match configuration for other connected devices
Select Port Speed 10 megabits, 100 megabits
Select Duplex Mode Half Duplex, Full Duplex
Services Page
The S ERVICES page opens when you select the C ONFIGURATION folder in the
menu on the left side of the page, and then click the S ERVICES link. Use this page
to disable the adaptor's web server, or to change the password.