ProSoft Technology ILX34-AENWG - Manual (Page 39)

ILX34-AENWG ♦ Point I/O Platform Configure the ILX34-AENWG
Wireless POINT I/O Adapter User Manual
ProSoft Technology, Inc. Page 39 of 177
August 16, 2013
Important: The IP address on the ILX34-AENWG's thumbwheel switches must match the IP
address you enter here.
2.3.1 Configure Chassis Size
The ILX34-AENWG requires configuration of its chassis size before you can
make any I/O connections. The default setting for the chassis size is 1 slot, which
represents the adapter by itself, and allows for no I/O.
You must set the chassis size to a number equaling 1 slot for the adapter plus 1
slot for each I/O module present in the adapter's backplane. For example, the
adapter plus 2 I/O modules uses a chassis size of 3. The adapter stores this
chassis size setting in non-volatile storage.
When the adapter's non-volatile chassis size does not match the actual number
of modules present on its backplane, the adapter does not make any I/O
connections and an error occurs.