ProSoft Technology ILX34-AENWG - Manual (Page 170)

Reference ILX34-AENWG ♦ Point I/O Platform
User Manual Wireless POINT I/O Adapter
Page 170 of 177 ProSoft Technology, Inc.
August 16, 2013
6.7 Using the ILX34-AENWG with Earlier Versions of RSLogix 5000
You can use the ILX34-AENWG module with earlier versions (16 and lower) of
RSLogix 5000, however earlier versions of RSLogix 5000 do not support the
Add-On Profile that provides configuration and statistics tabs for the wireless
portion of the ILX34-AENWG.
 Add the ILX34-AENWG adapter as a Rockwell Automation 1734-AENT
 Make sure to disable keying in the 1734-AENT profile.
 The only configuration interface for the wireless portion of the adapter is
through the configuration web Wireless Settings Page (page 31). You must
connect to the ILX34-AENWG with an Ethernet cable to configure the
wireless settings for the first time. After the wireless portion of the adapter is
configured, you can reconfigure the adapter over-the-air.
6.8 Additional Point I/O Documentation
The following related publications are available from Rockwell Automation's web
site at literature.rockwellautomation.com.
Topic Document Title Publication Number
Using EtherNet/IP for
industrial control EtherNet/IP Performance and Application
Guide ENET-AP001
EtherNet/IP media EtherNet/IP Media Planning and Installation
Guide ENET-IN001
Ethernet communication
interface modules Ethernet Communication Interface Module
Installation Instructions 1756-IN053
Ethernet Communication Interface Module
User Manual 1756-UM051
Ethernet Communication Interface Module
Release Notes 1756-RN053
ControlLogix chassis ControlLogix Chassis Installation Instructions 1756-IN080 (series B)
ControlLogix power
supplies ControlLogix Power Supplies Installation
Instructions 1756-5.67
(PA72/PB72)
Logix5555 programmable
controllers Logix5555 Controller User Manual 1756-UM523
SoftLogix5800 Controller SoftLogix5800 User Manual 1789-UM002 (L10,
L30, L60)
ControlLogix EtherNet/IP
bridge module with
firmware revision 2.3 or
later ControlLogix EtherNet/IP Bridge Module
Installation Instructions 1756-IN019
RSLogix 5000
programming software Getting Results with RSLogix 5000, version
3.2.1 or later 9399-RLD300GR
1734-AENT adapter POINT I/O EtherNet/IP Adapter Installation
Instructions 1734-IN590
POINT I/O digital and
analog modules and
PointBLOCK I/O modules POINT I/O Digital and Analog Modules and
PointBLOCK I/O Modules User Manual 1734-UM001
POINT I/O interface
modules POINT I/O RS-232 ASCII Module User
Manual 1734-UM009