ProSoft Technology ILX34-AENWG - Manual (Page 49)

ILX34-AENWG ♦ Point I/O Platform About the Example Applications
Wireless POINT I/O Adapter User Manual
ProSoft Technology, Inc. Page 49 of 177
August 16, 2013
Quantity Product Name Catalog Number
1 POINT I/O relay output module 1734-OW2/C
1 DIN rail 199-DR1 or equivalent
1 ControlLogix chassis 1756-A4, (or 1756-A7, 1756-A13,1756-A17)
1 ControlLogix power supply 1756-PA72, (or 1756-PB72)
1 ControlLogix controller 1756-L5* with firmware version 17
1 ControlLogix EtherNet/IP bridge
module 1756-ENBT with firmware version 4.007 or
higher
1 RadioLinx Industrial Hotspot RLXIB-IHW
1 Personal computer that supports
RSLogix 5000 software Any appropriate model running Windows NT
4.0, Service Pack 6A or higher
1 Ethernet switch Refer to manufacturer's specifications
1 24V dc power supply
Associated media and connectors as needed
Software
1 RSLinx communications software,
version 2.54.00 or later 9355-WAB, 9355-WABOEM, 9355-WABC
1 RSLogix 5000 programming
software,
version 17 or later 9324-RLD300ENE
3.3 Set Up the Hardware
In these examples, a ControlLogix chassis contains the Logix controller in slot 0,
and a 1756-ENBT bridge module in slot 3. We mounted the ILX34-AENWG
adapter on a DIN rail in slot 0, with a 1734-OW2/C relay output module in slot 1,
a 1734-OV4E/C sink output module in slot 2, and a 24 volt DC power supply.
To work along with this example, set up your system as follows.
 Note that the example application, the Logix controller and 1756-ENBT
module (firmware revision 4.007 or later) uses the slots shown in the About
the Example Applications (page 47).
 Verify the IP addresses for your programming terminal, 1756-ENBT module,
and ILX34-AENWG adapter.
 Verify the position (slot) of the I/O modules on the DIN rail.
 Verify that you have properly connected all wiring and cabling.
 You must configure your communication driver (such as AB_ETH-1 or AB-
ETHIP-1) in RSLinx software, as described in Configure the RSLinx Ethernet
Communication Driver.
3.4 Example 1 - Direct Connection and Rack Optimization
This example configures your ILX34-AENWG for both direct connection and rack
optimization using RSLogix 5000 software.
You can mix communication formats for different I/O modules communicating
through the same adapter.