RISCO Group Gardtec 490X - Manual (Page 51)

Page 50
GT490X Engineer’s Reference Guide
16) Press Yes. The display will show:-
When programming Digicom Channels Channel 1 is normally Fire, Channel 2 is
normally PA (Panic), Channel 3 is normally Alarm (unconfirmed) and Channel 4
is normally Open/Close.
Channels 5, 6, 7 & 8 will be advised by your Central Station.
Other signals you may require for BS8243 are.
Alarm Abort
Zone Exclude
Alarm B (Confirmed)
Channel settings available are:
Off
Zone 24Hr
Gen. Tamper
Alert
Fire
Part-Set
Open/Close
Panic
Alarm
Alarm B
Alarm Abort
Power Fail
Watchdog
Mains Fail
PSU Fail
Perimeter
Zone Exclude
Const. Lo-Bat
(Radio)
Radio Lost (Radio)
Const. Jam (Radio)
Any Fault
Any Mask
Power Fail Latch.
Global Fault -
This ‘Global Fault’ is a fast format communication channel option. With a
channel programmed as ‘Global Fault’ the channel will trigger when one of the
following faults occur: Mains Fail, PSU Fail, Battery Fault, Line Fault, others...
Engineer On Site
17) Press No until the required setting is displayed.
Ch1 = Off
Ch4 = Off
PR5851 Rev12 490X Eng Ref Guide.qxd 10/05/2012 11:33 Page 50