RISCO Group Gardtec 490X - Manual (Page 3)

IMPORTANT!
Input: AC230V +/-10% ~50Hz 125mA Max. 35W Max
Nominal Temp Range: 0 - 50ºC
Humidity 70% non-condensing
GT490X Metal
For Indoor Use Only
This equipment is intended only for use as a Security Alarm Control Panel. Adequate
ventilation away from heat and humidity must be provided. The unit must be fixed
securely to a non-flammable surface using suitable fixings.
All mains wiring must conform to the relevant current IEEE wiring regulations (or
appropriate international regulatory standards). See Mains Supply Connection section
within this manual for more detailed instructions.
All wiring must be protected from sharp or jagged edges.
All low voltage (alarm) wiring must be to the appropriate international regulatory
standards and comply to good wiring practice and should be routed away from the
mains cables.
Replacement fuses should be of the same type and rating conforming to IEC 127.
The GT490X Control Panel is fitted with resettable fuses. The areas protected are
Battery, Aux and Keypad. In the event of a fuse tripping or an input/ output not
working, remove the source of the load and check wiring for shorts. Check any added
devices for full functionality before any reconnection.
The maximum current draw from the unit for all output combinations must not exceed
1A.
Sounders, detectors and other auxiliary items, including the control panel and
keypad(s), should be included when calculating current drawn by the system.
Any damage caused through overloading the Control Panel Supply will not be covered
by the warranty.
We recommend that additional power supplies are used to supply detectors on long
cable runs.
The unit is intended for use with a suitable re-chargeable lead acid battery
permanently connected to the appropriate terminals.
All documentation and manuals must be thoroughly read by suitably qualified
installation personnel prior to installation.
Page 2
GT490X Engineer’s Reference Guide
PR5851 Rev12 490X Eng Ref Guide.qxd 10/05/2012 11:32 Page 2