RISCO Group Gardtec 490X User Manual

Page 47

Page

GT490X Engineer’s Reference Guide

The available options for the Quick Key are.

Off

The Quick Key is disabled

Quick-Set

Reduces the Exit Time after Exit has started.

Full-Set

Enter user code then Quick Key

Part-Set

Enter user code then Quick Key for Part 1 Set

16)

Press No until the required setting is displayed
then press Yes. The display will show:-

17)

Press No. The display will show:-

This option is used to program the Number of Keypads you have on the system.
It should be noted the there are no jumpers in the RKP to ident them this is done
from the program option.

18)

Press Yes. The display will show:-

19)

Press Yes. The display will show:-

20)

Enter the Number of the keypad you wish to
program onto the system (1 to 4) then press
Yes. The display will show:-

21)

Press the No & the Yes buttons together on the
selected keypad. The display will show:-

Program Keypad
Quick Key ?

Program Keypad
Number ?

Install Keypad ?

Enter Keypad # _
then +YES or -NO

Press NO + YES on
Selected Keypad

Keypad Installed
OK . . .

PR5851 Rev12 490X Eng Ref Guide.qxd 10/05/2012 11:33 Page 46