RISCO Group Gardtec 490X - Manual (Page 38)

Page 37
GT490X Engineer’s Reference Guide
Auto Part Set allows the system to decide if the Setting should be Full Set or
Part 1 Set. In order to use this option the Setting Mode for Full Set MUST be
Time+E/E and a Door Contact must be fitted to the door.
If the system sees the door open and close during a setting procedure the
system will Full Set.
If the system does not see the door open and close during a setting procedure
the system will Part 1 Set.
It is not possible to use Silent Part Sets with this option as the decision to do a
Part 1 set is taken after the Entry Time has expired.
41) Press Yes. The display will show:-
42) To change this press No twice.
The display will show:-
43) Press Yes. The display will show:-
44) This concludes the programming for
Setting Modes. Press 0 (zero) to return to:-
Or
Press 0 (zero) until the display shows:-
Program Setting
for Auto-Part ?
Auto Part-Set
= Off
Auto Part-Set
= On
Program . . . . _ _ _
Setting Modes ?
01 Jan 00: 00: 01
PR5851 Rev12 490X Eng Ref Guide.qxd 10/05/2012 11:32 Page 37