RISCO Group Gardtec 490X - Manual (Page 104)

To test the charge voltage, connect a test meter as per figure 2.
Connect one meter lead to the battery by pushing the probe under the insulation of the
battery spade.
Then remove the other battery lead and connect to the other meter lead. The meter will
now show the battery charge voltage. Note that the voltage will drop off within 10
seconds. Repeat the above if required.
Page 103
GT490X Engineer’s Reference Guide
Fig 2.
PR5851 Rev12 490X Eng Ref Guide.qxd 10/05/2012 11:33 Page 103