RISCO Group Gardtec 490X User Manual

Page 43

Page

GT490X Engineer’s Reference Guide

13)

Press No. The display will show:-

14)

Press Yes. The Display will show:-

15)

Press No twice. The display will show:-

16)

Enter the Bell Ring Time you require(in minutes)
followed by Yes. The display will show:-

Note: Bell Ring is defaulted to 10 minutes and is programmable from a minimum of 1 minute to a
maximum of 15 minutes.

The term Sounder refers to the Internal Speakers fitted to the system and also
the speaker(s) fitted to the RKPs

Options available for Sounder are.

Constant

Will continue after the Bell Time has elapsed.

Timed

Will Time out with the Bell Time

17)

Press No until your required setting is displayed
then press Yes. The display will show:-

The Strobe light will normally continue after the Bell Time has elapsed. You may
Time the Strobe if required. To do so.

18)

Press No twice. The display will show:-

19)

Enter the time required (in minutes) followed by
Yes. The display will show:-

Note: Strobe Timer is defaulted to 0 minutes but is programmable to a maximum of 120 minutes.

Program Bell
& Sounder Ring ?

Bell Ring = 10 m
Sounder = Constant

Bell Ring = _ _ m
Sounder = Constant

Bell Ring = 15 m
Sounder > Constant

Strobe Timer
= 000 m

Strobe Timer
= _ _ _ m

PR5851 Rev12 490X Eng Ref Guide.qxd 10/05/2012 11:33 Page 42