Xerox WorkCentre 7835ii - Manual (Page 97)

Security
Xerox ® WorkCentre ® 7800/7800i Series Color Multifunction Printer 97
System Administrator Guide
Enabling FIPS 140 Mode and Checking for Compliance
1. In Xerox ® CentreWare ® Internet Services, click Properties > Security > Encryption.
2. Click FIPS 140-2.
3. Click Enable.
4. Click Run Configuration Check and Apply.
A pass or fail message appears:
−
If the configuration check passes, click Reboot Machine to save and restart the printer.
− If the configuration check fails, the reasons for the failed test list in a table at the bottom of
the page. For each reason, a link is provided. Click the appropriate link to disable the protocol,
replace the certificate, or allow the printer to use the non-compliant protocol.
Note: When FIPS 140 Mode is enabled, only FIPS-compliant certificates can be installed on the
printer.