HEIDENHAIN iTNC 530 (340 49x-03) - Manual (Page 9)

HEIDENHAIN iTNC 530 9
TNC Model, Sof
tw
a
re
and F
eat
ur
es
Location of use
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
Legal information:
This product uses open source software. Further information is
available on the control under
8 Programming and Editing operating mode
8 MOD function
8 LEGAL INFORMATION soft key
Possibility of assigning different depths
to each subcontour in the contour
formula Page 463
DHCP dynamic IP-address
management Page 681
Touch-probe cycle for global setting of
touch-probe parameters Touch Probe Cycles
User’s Manual
smarT.NC: Graphic support of block
scan smarT.NC Pilot
smarT.NC: Coordinate transformation smarT.NC Pilot
smarT.NC: PLANE function smarT.NC Pilot
FCL 2 functions Description