HEIDENHAIN iTNC 530 (340 49x-03) - Manual (Page 685)

HEIDENHAIN iTNC 530 685
13.6 Ether
n
et Int
e
rf
ace
Network settings specific to the device
8 Press the soft key DEFINE MOUNT to enter the network settings
for a specific device. You can define any number of network
settings, but you can manage only seven at one time.
NAMESERVER Network address of the domain server. If
DOMAIN and NAMESERVER are defined, you
can use symbolic PC names in the mount table,
obviating the need for entering the IP address.
As an alternative, you can also assign DHCP for
dynamic management.
You do not need to indicate the protocol with the
iTNC 530. It uses the transmission protocol according to
RFC 894.
Setting Meaning
Setting Meaning
MOUNT-
DEVICE
„
Connection via NFS:
Name of the directory that is to be logged on.
This is formed by the network address of the
server, a colon and the name of the directory
to be mounted. Input: four numerical values
separated by points. Ask your network
specialist for the values, e.g. 160.1.13.4.
Directory of the NFS server that you wish to
connect to the TNC. Be sure to differentiate
between small and capital letters when
entering the path.
„ Connection via smb:
Enter the network name and the share name
of the computer, e.g. //PC1791NT/C
MOUNTPOINT Name that the TNC shows in the file manager
for a connected device. Remember that the
name must end with a colon.
FILESYSTEM-
TYPE File system type.
NFS:
Network File System
SMB: Server Message Block (Windows protocol)