Input parameters – HEIDENHAIN iTNC 530 (340 49x-03) User Manual
Page 527
HEIDENHAIN iTNC 530
527
9.6 Defining the Mac
h
ining Plan
e via Thr
ee P
o
ints: POINTS
PLANE
Input parameters
8
X coordinate of 1st plane point?:
X coordinate P1X
of the 1st plane point (see figure at top right).
8
Y coordinate of 1st plane point?:
Y coordinate P1Y
of the 1st plane point (see figure at top right).
8
Z coordinate of 1st plane point?:
Z coordinate P1Z
of the 1st plane point (see figure at top right).
8
X coordinate of 2nd plane point?:
X coordinate P2X
of the 2nd plane point (see figure at center right).
8
Y coordinate of 2nd plane point?:
Y coordinate P2Y
of the 2nd plane point (see figure at center right).
8
Z coordinate of 2nd plane point?:
Z coordinate P2Z
of the 2nd plane point (see figure at center right).
8
X coordinate of 3rd plane point?:
X coordinate P3X
of the 3rd plane point (see figure at bottom right).
8
Y coordinate of 3rd plane point?:
Y coordinate P3Y
of the 3rd plane point (see figure at bottom right).
8
Z coordinate of 3rd plane point?:
Z coordinate P3Z
of the 3rd plane point (see figure at bottom right).
8
Continue with the positioning properties (see
“Specifying the Positioning Behavior of the PLANE
Function” on page 531).
NC block
Abbreviations used
5 PLANE POINTS P1X+0 P1Y+0 P1Z+20 P2X+30 P2Y+31 P2Z+20
P3X+0 P3Y+41 P3Z+32.5 .....
Abbreviation
Meaning
POINTS
Points