Input parameters – HEIDENHAIN iTNC 530 (340 49x-03) User Manual
Page 525

HEIDENHAIN iTNC 530
525
9.5 Defining the Mac
h
ining Plane
with T
w
o V
e
ct
ors: VECT
OR
PLANE
Input parameters
8
X component of base vector?:
X component BX of the
base vector B (see figure at top right). Input range: -
99.9999999 to +99.9999999
8
Y component of base vector?:
Y component BY of the
base vector B (see figure at top right). Input range: -
99.9999999 to +99.9999999
8
Z component of base vector?:
Z component BZ of the
base vector B (see figure at top right). Input range: -
99.9999999 to +99.9999999
8
X component of normal vector?:
X component NX of
the normal vector N (see figure at center right). Input
range: -99.9999999 to +99.9999999
8
Y component of normal vector?:
Y component NY of
the normal vector N (see figure at center right). Input
range: -99.9999999 to +99.9999999
8
Z component of normal vector?:
Z component NZ of
the normal vector N (see figure at lower right). Input
range: -99.9999999 to +99.9999999
8
Continue with the positioning properties (see
“Specifying the Positioning Behavior of the PLANE
Function” on page 531).
NC block
Abbreviations used
5 PLANE VECTOR BX0.8 BY-0.4 BZ-
0.4472 NX0.2 NY0.2 NZ0.9592 .....
Abbreviation
Meaning
VECTOR
Vector
BX, BY, BZ
Base vector: X, Y and Z components
NX, NY, NZ
Normal vector: X, Y and Z components