HEIDENHAIN iTNC 530 (340 49x-03) - Manual (Page 144)

144 4 Fundamentals of NC, File Management, Programming Aids, Pallet Management
4.6 3-D Line Gr
aphics (FCL
2
F
unction)
Functions of the 3-D line graphics
Function Soft key
Show and move the zoom frame up. Press and
hold the soft key to move the frame.
Show and move the zoom frame down. Press
and hold the soft key to move the frame.
Show and move the zoom frame to the left.
Press and hold the soft key to move the frame.
Show and move the zoom to the right. Press and
hold the soft key to move the frame.
Enlarge the frame overlay—press and hold the
soft key to magnify the detail.
Reduce the frame overlay—press and hold the
soft key to reduce the detail.
Reset detail magnification so that the workpiece
is displayed as it was programmed with BLK
FORM.
Select the isolated detail
Rotate workpiece clockwise
Rotate workpiece counterclockwise
Tilt workpiece backward
Tilt workpiece forward
Magnify the graphic stepwise. If the view is
magnified, the TNC shows the letter Z in the
footer of the graphic window.
Reduce the graphic stepwise. If the view is
reduced, the TNC shows the letter Z in the footer
of the graphic window.
Show workpiece at original size
Show workpiece in the last active view
Show/hide programmed end points with a dot on
the line