HEIDENHAIN iTNC 530 (340 49x-03) - Manual (Page 593)

HEIDENHAIN iTNC 530 593
1
1
.8 A
d
ditional F
u
nctions
Current position in the active
coordinate system, 270 1 1 X axis
2 Y axis
3 Z axis
4 A axis
5 B axis
6 C axis
7 U axis
8 V axis
9 W axis
Status of M128, 280 1 - 0: M128 inactive, –1: M128 active
2 - Feed rate that was programmed with M128
Status of M116, 310 116 - 0: M116 inactive, –1: M116 active
128 - 0: M128 inactive, –1: M128 active
144 - 0: M144 inactive, –1: M144 active
TS triggering touch probe, 350 10 - Touch probe axis
11 - Effective ball radius
12 - Effective length
13 - Radius setting ring
14 1 Center misalignment in reference axis
2 Center misalignment in minor axis
15 - Direction of center misalignment compared with 0°
position
TT tool touch probe 20 1 Center point X axis (REF system)
2 Center point Y axis (REF system)
3 Center point Z axis (REF system)
21 - Probe contact radius
Last touch point in TCH PROBE
Cycle 0 or last touch point from
manual operating mode, 360 1 1 to 9 Position in the active coordinate system in axes 1 to 9
2 1 to 9 Position in the REF system in axes 1 to 9
Group name, ID No. Number Index Meaning