HEIDENHAIN iTNC 530 (340 49x-03) - Manual (Page 653)

HEIDENHAIN iTNC 530 653
12.8 Global Pr
ogr
a
m Set
tings (Sof
tw
ar
e Option)
12.8 Global Program Settings
(Software Option)
Function
The global program settings, which are used in particular for large
molds and dies, are available in the Program Run mode and MDI
mode. You can use it to define various coordinate transformations and
settings that are globally effective and are superimposed on the
respectively selected NC program so that you do not need to edit the
NC program.
You can activate and deactivate global program settings, even in mid-
program if you have interrupted the program run (see “Interrupting
machining” on page 641).
The following global program settings are available:
Function Icon Page
Exchanging axes Page 656
Basic rotation Page 656
Additional, additive datum shift Page 657
Superimposed mirroring Page 657
Superimposed rotation Page 658
Axis locking Page 658
Definition of a handwheel
superimposition Page 659
Definition of a globally effective feed rate
factor Page 658