HEIDENHAIN iTNC 530 (340 49x-03) - Manual (Page 655)

HEIDENHAIN iTNC 530 655
12.8 Global Pr
ogr
a
m Set
tings (Sof
tw
ar
e Option)
The remaining functions such as axis locking, handwheel
superimposition and feed rate factor act independently.
The functions in the following list help you to navigate in the form. You
can also use the mouse to use the form.
If you activate more than one global program setting, the
TNC calculates the transformations internally in the
following sequence:
„ 1: Axis exchange
„
2: Basic rotation
„
3: Shift
„ 4: Mirroring
„ 5: Superimposed rotation
Function
Key/
Soft key
Jump to previous function
Jump to next function
Select the next element
Select the previous element
Axis exchange function: Open the list of available axes
Switch the function on/off if the cursor is on a
checkbox.
Reset the global program settings:
„ Deactivate all functions
„ Set all entered value to 0, set feed rate factor to 100.
Set basic rotation to 0 if no preset is active in the
preset table. Otherwise the TNC defines the preset
at the basic rotation entered in the preset table.
Discard all changes since the form was last called
Deactivate all active functions. The entered or adjusted
values remain.
Save all changes and close the form