HEIDENHAIN iTNC 530 (340 49x-03) - Manual (Page 146)

146 4 Fundamentals of NC, File Management, Programming Aids, Pallet Management
4.6 3-D Line Gr
aphics (FCL
2
F
unction)
Highlighting NC blocks in the graphics
8 Shift the soft-key row.
8 To highlight the NC block selected in the left window
in the 3-D line graphics in the right window, set the
MARK THIS ELEMENT OFF / ON soft key to ON.
8 To not highlight the NC block selected in the left
window in the 3-D line graphics in the right window,
set the MARK THIS ELEMENT OFF / ON soft key to
OFF.
Block number display ON/OFF
8 Shift the soft-key row.
8 To show block numbers: Set the SHOW OMIT BLOCK
NR. soft key to SHOW.
8 To omit block numbers: Set the SHOW OMIT BLOCK
NR. soft key to OMIT.
Erasing the graphic
8 Shift the soft-key row.
8 Delete graphic: Press CLEAR GRAPHIC soft key.