HEIDENHAIN iTNC 530 (340 420) ISO programming - Manual (Page 96)

96 4 Programming: Fundamentals of NC, File Management, Programming Aids, Pallet Management
4.5 Cr
eating and W
riting Pr
ogr
a
ms
Editing a program
While you are creating or editing a part program, you can select any
desired line in the program or individual words in a block with the
arrow keys or the soft keys:
Function Soft key/key
Go to previous page
Go to next page
Go to beginning of program
Go to end of program
Change the position of the current block on
the screen: Press this soft key to display
additional program blocks that are
programmed before the current block.
Change the position of the current block on
the screen: Press this soft key to display
additional program blocks that are
programmed after the current block.
Move from one block to the next
Select individual words in a block
Function Soft key/key
Set the selected word to zero
Erase an incorrect number
Clear a (non-blinking) error message
Delete the selected word
Delete the selected block
Insert the block that was last edited or deleted