6 checking and changing q parameters, Procedure – HEIDENHAIN iTNC 530 (340 420) ISO programming User Manual
Page 395
HEIDENHAIN iTNC 530
395
1
0
.6 Chec
king and Changing Q
P
ar
amet
ers
10.6 Checking and Changing
Q Parameters
Procedure
You can check and edit Q parameters when writing, testing and
running programs in the Programming and Editing, Test Run, Program
Run Full Sequence, and Program Run Single Block modes.
U
U
U
U
If you are in a program run, interrupt it if required (for example by
pressing the machine STOP button and the INTERNAL STOP soft
key). If you are in a test run, interrupt it.
U
U
U
U
To call Q parameter functions: Press the Q key or the
Q INFO soft key in the Programming and Editing
mode of operation.
U
U
U
U
The TNC lists all parameters and their current values.
With the arrow keys or the soft keys, go pagewise to
the desired parameters.
U
U
U
U
If you would like to change the value, enter a new
value and confirm with the ENT key.
U
U
U
U
To leave the value unchanged, press the PRESENT
VALUE soft key or end the dialog with the END key.
The parameters (parameter numbers > 100) used by the
TNC are provided with comments.