HEIDENHAIN iTNC 530 (340 420) ISO programming - Manual (Page 357)

HEIDENHAIN iTNC 530 357
8.1
0
Coor
di
na
te T
ra
n
s
for
m
ati
on Cy
cle
s
ROTATION (Cycle G73)
The TNC can rotate the coordinate system about the active datum in
the working plane within a program.
Effect
The ROTATION cycle becomes effective as soon as it is defined in the
program. It is also effective in the Positioning with MDI mode of
operation. The active rotation angle is shown in the additional status
display.
Reference axis for the rotation angle:
n X/Y plane X axis
n Y/Z plane Y axis
n Z/X plane Z axis
U U U U Rotation: Enter the rotation angle in degrees (°). Input
range: -360° to +360° (absolute G90 before H or
incremental G91 before H).
Cancellation
Program the ROTATION cycle once again with a rotation angle of 0°.
Example: NC block
N72 G73 G90 H+25 *
Z
Z
X
X
Y
Y
Before programming, note the following:
An active radius compensation is canceled by defining
Cycle G73 and must therefore be reprogrammed, if
required.
After defining Cycle G73, you must move both axes of the
working plane to activate rotation for all axes.