HEIDENHAIN iTNC 530 (340 420) ISO programming - Manual (Page 447)

HEIDENHAIN iTNC 530 447
12.5 Ether
n
et Int
e
rf
ace
12.5 Ethernet Interface
Introduction
The TNC is shipped with a standard Ethernet card to connect the
control as a client in your network. The TNC transmits data through the
Ethernet card in accordance with the Transmission Control Protocol/
Internet Protocol (TCP/IP) family of protocols and with the aid of the
Network File System (NFS).
Connection possibilities
You can connect the Ethernet card in your TNC to your network
through the RJ45 connection (X26, 100BaseTX). The connection is
metallically isolated from the control electronics.
RJ45 connection X26 (100BaseTX or 10BaseT)
For a 100BaseTX or 10BaseT connection you need a Twisted Pair
cable to connect the TNC to your network.
The maximum cable length between TNC and a node
depends on the quality grade of the cable, the sheathing
and the type of network (100BaseTX or 10BaseT).
If you connect the TNC directly with a PC you must use a
transposed cable.
PC
TNC
10BaseT / 100BaseTx