HEIDENHAIN iTNC 530 (340 420) ISO programming - Manual (Page 488)

488 13 Tables and Overviews
13.3 T
e
c
hnical Inf
o
rm
ation
Input format and unit of TNC functions
Positions, coordinates, circle radii, chamfer
lengths –99 999.9999 to +99 999.9999
(5.4: places before decimal point, places after decimal point) [mm]
Tool numbers 0 999 99 to 32 767.9 999 99 (5.1)
Tool names 16 characters, enclosed by quotation marks with TOOL CALL. Permitted
special characters: #, $, %, &, -
Delta values for tool compensation –99.9999 to +99.9999 (2.4) [mm]
Spindle speeds 0 to 99 999.999 (5.3) [rpm]
Feed rates 0 to 99 999.999 (5.3) [mm/min] or [mm/rev]
Dwell time in Cycle 9 0 to 3600.000 (4.3) [s]
Thread pitch in various cycles –99.9999 to +99.9999 (2.4) [mm]
Angle of spindle orientation 0 to 360.0000 (3.4) [°]
Angle for polar coordinates, rotation, tilting
the working plane -360.0000 to 360.0000 (3.4) [°]
Polar coordinate angle for helical
interpolation (CP) –5400.0000 to +5400.0000 (4.4) [°]
Datum numbers in Cycle 7 0 999 99 to 2 999 999 99 (4.0)
Scaling factor in Cycles 11 and 26 0.000 001 to 99.999 999 (2.6)
Miscellaneous functions M 0 999 99 to 999 999 99 (1.0)
Q parameter numbers 0 999 99 to 399 999 99 (1.0)
Q parameter values -99 999.9999 999 99 to +99 999.9999 999 99 (5.4)
Labels (LBL) for program jumps 0 999 99 to 254 999 99 (3.0)
Number of program section repeats REP 1 999 99 to 65 534 999 99 (5.0)
Error number with Q parameter function
FN14 0 999 99 to 1 099 999 99 (4.0)
Spline parameter K –9.999 999 99 to +9.999 999 99 (1.8)
Exponent for spline parameter -255 999 99 to 255 999 99 (3.0)
Surface-normal vectors N and T with 3-D
compensation –9.999 999 99 to +9.999 999 99 (1.8)