HEIDENHAIN iTNC 530 (340 420) ISO programming - Manual (Page 284)

284 8 Programming: Cycles
8.4 Cy
cles f
o
r Milling P
o
c
k
ets, St
uds and Slots
U U U U Set-up clearance 1 (incremental value): Distance
between tool tip (at starting position) and workpiece
surface.
U U U U Milling depth 2 (incremental value): Distance
between workpiece surface and bottom of pocket
U U U U Plunging depth 3 (incremental value): Infeed per cut.
The tool will drill to the depth in one operation if:
n the plunging depth is equal to the depth
n the plunging depth is greater than the depth
U U U U Feed rate for plunging: Traversing speed during
penetration.
U U U U 1st side length 4 : Slot length; specify the sign to
determine the first milling direction.
U U U U 2nd side length 5 : Slot width.
U U U U Feed rate F: Traversing speed of the tool in the
working plane.
Example: NC block
N44 G74 P01 2 P02 -20 P0 5 P04 100
P05 X+80 P06 Y+12 P07 275 *
12
13
14
15
1