HEIDENHAIN iTNC 530 (340 420) ISO programming - Manual (Page 389)

HEIDENHAIN iTNC 530 389
1
0
.3 Descr
ibing Cont
ours thr
ough Mathematical Oper
ations
10.3 Describing Contours through
Mathematical Operations
Function
The Q parameters listed below enable you to program basic
mathematical functions in a part program:
U U U U Select a Q parameter function: Press the Q key (in the numerical
keypad at right). The Q parameter functions are displayed in a soft-
key row.
U U U U To select the mathematical functions: Press the BASIC
ARITHMETIC soft key. The TNC then displays the following soft
keys:
Overview
To the right of the “=” character you can enter the following:
n
Two numbers
n
Two Q parameters
n A number and a Q parameter
The Q parameters and numerical values in the equations can be
entered with positive or negative signs.
Function Soft key
D00: ASSIGN
Example: D00 Q5 P01 +60 *
Assigns a numerical value.
D01: ADDITION
Example: D01 Q1 P01 -Q2 P02 -5 *
Calculates and assigns the sum of two values.
D02: SUBTRACTION
Example: D02 Q1 P01 +10 P02 +5 *
Calculate and assign the difference of two values
D03: MULTIPLICATION
Example: D03 Q2 P01 +3 P02 +3 *
Calculate and assign the product of two values
D04: DIVISION
Example: D04 Q4 P01 +8 P02 +Q2 *
Calculates and assigns the quotient of two values.
Not permitted: division by 0
D05: SQUARE ROOT
Example: D05 Q50 P01 4 *
Calculates and assigns the square root of a number.
Not permitted: Square root of a negative number