Grass Valley NewsBrowse Desktop Browsing System Installation v.2.7 - Manual (Page 73)

December 16, 2004 NewsBrowse Installation and Configuration Guide 73
Router Gateway stand-alone stage
For this configuration stage you configure the Router Gateway component for control
of your router controller (if used in your system).
Refer to “Two tier system diagram” on page 10 for a view of the entire NewsBrowse
system.
To do the basic configuration and testing of the Router Gateway stand-alone stage, do
the following:
1. “Add Router Gateway” on page 73
2. “Configure ASK Location: Router Gateway” on page 74
3. “Configure Router Gateway” on page 74
4. “Test: Router Gateway stand-alone stage” on page 74
5. “Checklist: Router Gateway stand alone stage” on page 75
Add Router Gateway
The machine that hosts the Router Gateway software component acts as the Router
Gateway machine, as follows:
Dedicated Router Gateway — In some NewsBrowse systems, the Router Gateway
software component is on a stand-alone Router Gateway machine. If your system has
a dedicated Router Gateway machine, it comes from the factory with the Router
Gateway software component installed, so you do not need to do any further
installation. The Router Gateway machine requires only network connections in
preparation for its use in the NewsBrowse system.
MDI server as Router Gateway — The Router Gateway software component can also
reside on another NewsBrowse machine, such as the MDI server. If your system uses
the MDI server as the Router Gateway host, you must first install the Router Gateway
software component from the NewsBrowse server installation program. Run the
installation program and install only
Router Gateway .
Router Gateway stand-alone stage